https://popups.uliege.be/esaform21/index.php?id=2466 Index terms fr 0 https://popups.uliege.be/esaform21/index.php?id=3627 The additive manufacturing has initially gained popularity for production of non-loadbearing parts and components or in the fields where the material strength and ductility are less important such as modelling and rapid prototyping. But as the technology develops, availability of metal additive manufacturing naturally dictates the desire to use the produced components in load-bearing parts. This requires not-only a thorough documentation on the mechanical properties but also additional and independent research to learn the expected level of variation of the mechanical properties and what factors affect them. The presented paper investigates strength, ductility, hardness, and microstructure of the AlSi10Mg alloy produced by the selective laser melting (SLM). The mechanical properties were determined through a series of uniaxial tension tests and supplementary hardness tests and rationalized with the microstructure evolution with regard to printing direction and heat treatment. The paper also addresses the effect of surface roughness on the mechanical properties of the material, by comparing the machined and net shape tension samples. As expected, the as-manufactured AlSi10Mg-alloy appears to be a semi-brittle alloy, but its microstructure can be altered, and ductility increased by a proper heat-treatment. The effect of surface layer removal on the measured mechanical properties is of particular interest. Mon, 29 Mar 2021 13:43:07 +0200 Thu, 08 Apr 2021 18:39:38 +0200 https://popups.uliege.be/esaform21/index.php?id=3627 https://popups.uliege.be/esaform21/index.php?id=2464 Laser powder bed fusion (LPBF) is an additive manufacturing technique that is widely used to produce AlSi10Mg parts with a good strength-to-weight ratio and a very fine microstructure thanks to high cooling rates. However, to obtain better mechanical properties, a good ductility and higher fatigue resistance, post-treatments have to be performed. In this work, friction stir processing, a thermomechanical post-treatment, is applied on an as-built plate of 5 mm of thickness. This post-treatment leads to a decrease of the percentage of porosities and to modification of the microstructure: globularized Si-rich particles are surrounded by the α-Al phase. The method presented uses nanoindentation to determine the behavior of the different phases present in the material for future numerical simulations and a better understanding of the relation between microstructure and fatigue strength. The Bucaille method [1] is used to determine the links between indentation curves and elastoplastic parameters. Three different pyramidal indenters are used: Berkovich, cube corner and an indenter with a centerline-to-face angle of 50 degrees. From the loading / unloading curves and after post-processing, the Young's modulus, the representative strain and the associated stress are determined. With the three different indenters and their three true stress/true strain points, a good description of the elastoplastic behavior can be defined. Tue, 23 Mar 2021 19:28:40 +0100 Tue, 30 Mar 2021 09:33:34 +0200 https://popups.uliege.be/esaform21/index.php?id=2464