https://popups.uliege.be/esaform21/index.php?id=4793 Publications of Auteurs Sören Müller fr 0 https://popups.uliege.be/esaform21/index.php?id=4785 In copper extrusion, billet temperatures of 600°C or more are very common and the dies are therefore exposed to high thermo-mechanical stress. This causes deflection and wear of the dies and thus reduced quality of the extruded profile. In the present study, die deflection and residual deformation after several extrusion cycles was investigated by means of extrusion trials and numerical analyses. Material models of four tool materials (hot-work tool steels 1.2367 and CS1, nickel-based alloy 718, cobalt-based alloy Stellite 1) and the copper alloy CW024A were provided by hot compression tests. Extrusion trials were carried out applying four different dies, each made of another tool material. Using the FEM based software DEFORM 2D, the extrusion trials were modeled and decoupled die stress analyses were performed, which simulated three consecutive load cycles. The focus of the data interpretation was in die deflection in proximity of the die land due to the thermo-mechanical load and residual plastic deformation after relief of the mechanical load. Larger values of deflection close to the die land were observed for the hot-work tool steels, while the deflection of nickel- and cobalt-based alloys was negligibly small. Also, remarkable plastic deformation was only determined for the hot-work tool steels, with increasing values for every simulated load cycle. This analysis characterizes the performance limits of hot-work tool steels and the benefits of nickel- and cobalt-based alloys regarding contour accuracy during high temperature copper extrusion. Fri, 09 Apr 2021 10:12:11 +0200 Fri, 09 Apr 2021 10:26:11 +0200 https://popups.uliege.be/esaform21/index.php?id=4785 https://popups.uliege.be/esaform21/index.php?id=3714 Since its first synthesis in 2004 graphene was characterized intensively and exceptional properties in terms of e.g. mechanical strength, stiffness and electrical as well as thermal conductivity were revealed. These properties make graphene very attractive to be applied as additive in composite materials e.g. to increase strength and conductivity compared to the pure matrix material. In this study graphene nano platelets (GNP) in contents of 0. 5%, 1.0 % and 1.5 % were added to pure (99.7 %) aluminum powder and dispersed via EIRICH mixer method. This method is very appealing since homogenous mixtures can be achieved in significantly lower time when compared to e.g. the ball milling process. After subsequent cold compaction the composite materials were extruded with three different extrusion ratios. The influence of GNP content and extrusion ratio on the specific extrusion pressure is characterized as well the resulting rod surface quality, respectively. The effects of GNP content and extrusion ratio on homogeneity of graphene dispersion in the aluminum matrix, the relative density of the composite as well as hardness were also investigated. Mon, 29 Mar 2021 14:18:38 +0200 Fri, 14 May 2021 15:25:55 +0200 https://popups.uliege.be/esaform21/index.php?id=3714