https://popups.uliege.be/esaform21/index.php?id=959 Publications of Auteurs Tom Petersen fr 0 https://popups.uliege.be/esaform21/index.php?id=2697 Due to high thermo-mechanical loads, tools used in hot forming operations need a high resistance to different damage phenomena, such as deformation, cracking and abrasion. They are exposed to cyclic thermo-mechanical stress conditions, which leads to tool failure and subsequent tool replacement during cost-intensive production interruptions. To increase wear resistance, forging tools can be produced in the metastable austenite area. Forming of steel below the recrystallisation temperature, also known as “ausforming”, offers the possibility to increase strength without affecting ductile properties. This is due to grain refinement during forming. In this study, the thermo-mechanical treatment ausforming will be used to form the final contour of forging dies. For this purpose, an analogy study was performed where a cup-preform is ausformed, which represents the inner contour of a highly mechanically loaded forging die. It is investigated to what extent a fine-grained microstructure generated in the last forming stage can be achieved and how it influences the tool’s performance. The hot-working tool steel X37CrMoV5-1 (AISI H11) was used as workpiece material. To achieve optimal properties, process routes with tempering temperatures from 300 °C to 500 °C and global true plastic strains of φ = 0.25 and φ = 0.45 were examined. The results were evaluated by pulsation tests, metallographic analysis and hardness measurements of the formed parts. Optimal ausforming parameters were derived to produce a high performance forging die. Wed, 24 Mar 2021 18:45:22 +0100 Fri, 02 Apr 2021 15:49:17 +0200 https://popups.uliege.be/esaform21/index.php?id=2697 https://popups.uliege.be/esaform21/index.php?id=954 Multi-material solutions represent a promising approach for the production of load-optimised parts. The combination of material-specific advantages of different materials in a single component allows the fulfilment of conflicting requirements e.g. high performance and low weight. Fabrication of hybrid components is challenging due to the dissimilar properties of the individual materials and requires the development of suitable manufacturing technologies. The present paper deals with the simulation-based design of a forming process for the production of a suspension control arm consisting of steel and aluminium. With the focus on material flow, two forming concepts, open-die and closed-die forging, were investigated, in order to ensure the required material distribution similar to the final part. In addition, a tool analysis was carried out to avoid thermo-mechanical overload of the tool system. It was found that the required material distribution can be achieved with both forming concepts. However, a closed-die forging concept is not suitable because of the high stresses in the forging dies exceed the tool steel’s strength. Mon, 22 Mar 2021 10:30:37 +0100 Mon, 05 Apr 2021 18:22:43 +0200 https://popups.uliege.be/esaform21/index.php?id=954