Numerical design of load response in magneto-rheological actuators for sheet metal stamping

Michele Brun, Andrea Ghiotti, Enrico Simonetto and Stefania Bruschi

Online since 03 May 2021

Roughness development of polymer coated steel during the production process of a can

Jenny Venema, Fred Jonker and Richard Stegeman

Online since 12 April 2021

Influence of the sheet metal Seebeck coefficient on wear detection based on thermoelectric measurement

Yutian Wu, Chen Chen, Chengjun Wang and Peter Groche

Online since 12 April 2021

Temperature induced friction increase in friction test and forming demonstrator for sheet metal forming

Jan Filzek, Daniel Keil and Holger Schröder

Online since 08 April 2021

Forming defects prediction in cup drawing and embossing of a thick steel sheet

Marta Cristina Oliveira, Diogo M. Neto, Pedro D. Barros, José L. Alves and Luis F. Menezes

Online since 05 April 2021

Experimental Investigation of Process Forces and Part Quality for Fine Blanking of Stainless Steel with Inductive Heating

Ingo Felix Weiser, Robby Mannens, Andreas Feuerhack and Thomas Bergs

Online since 02 April 2021

Prediction and assessment of skid line formation during deep drawing of sheet metal components by using FEM simulation

Patrick Cyron, Mathias Liewald, Kim-Rouven Riedmüller and Thanh-Lich Le

Online since 31 March 2021

Rapid Tooling for Impulse Forming

Lasse Langstädtler, Alex Peer Intemann, Marius Herrmann, Christian Schenck, Holger Pegel and Bernd Kuhfuss

Online since 30 March 2021